Installing fan cowl with electric motor

Remove guard for the cooler fins 

• Remove guard (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Insert the fan cowl (1)  downwards to the coolant hoses.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Clip in the hose support (2)  to the fan cowl (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• F90 only: 

  Insert the front underbody protection (1)  .

• Slide the front underbody protection (1)  slightly backwards and insert it under the thrust field (2)  .
• Tighten all bolts (arrows).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Underbody protection
  Screw	Tightening torque	3 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Only for F91, F92, F93: 

  Insert the front underbody protection (1)  .

• Slide the front underbody protection (1)  slightly backwards and insert it under the thrust field (2)  .
• Tighten all bolts (arrows).

Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screw (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Clip in and secure wiring harness mountings (1)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screw (1)  .

• Connect plug connection (2)  and lock.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
• Refer to INSTALLING UPPER CROSS CONNECTION .
• Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
• Refer to TIGHTENING THE FRONT-END STRUT ON THE RIGHT .
• Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
• Refer to TIGHTENING THE LEFT FRONT-END STRUT .
• Refer to INSTALLING THE CENTER ENGINE COMPARTMENT COVER .
• Refer to INSTALLING THE FRONT HOOD SEAL .
• Refer to INSTALLING THE COVER PANEL OF THE MASTER DME CONTROL UNIT .
• Refer to INSTALLING THE COVER PANEL OF THE SLAVE DME CONTROL UNIT .