Mount rear brake guard plate
- Install brake guard plate (2) .
- Replace screws (1)
.
Parts: Screws
- Insert screws (1) and tighten.
TIGHTENING TORQUES SPECIFICATION
| Brake protection plate on the rear wheel carrier | ||
|---|---|---|
| M6x12 Replace screw. |
tightening torque | 8 Nm |
Follow-up work
- Refer to INSTALLING REAR BRAKE DISCS (CARBON CERAMIC BRAKE) .
- Refer to GREASING THE BRAKE PADS, THE BRAKE ANCHOR PLATE AND THE BRAKE CALIPER WITH BRAKE PAD PASTE .
- Refer to INSTALLING REAR BRAKE PADS .
- Refer to INSTALLING REAR BRAKE PAD WEAR SENSOR .
- Refer to INSTALLING REAR WHEEL ON THE LEFT AND RIGHT .
- Refer to START-UP OR BEDDING IN BREAK-IN OF NEW BRAKE PADS AND ROTORS (REAR BRAKE) .