Installing rear brake discs (carbon ceramic brake)
NOTE:
In the event of a repair, an individual brake disk (front axle/rear axle) may be exchanged. When replacing a brake disk (especially on the front axle), an exchange of the brake pads by axle is recommended because of the risk of initial skewing when braking during the break-in phase and the associated risk of repeat repairs. From a technical point of view, however, this is not absolutely necessary. Depending on the state of wear and the contact pattern of the brake pads, decisions must be taken on an individual basis according to the situation.
- Clean contact surface of wheel hub thoroughly and remove any traces of rust if necessary.
Irregularities in the contact surface can cause distortion in the brake disc!
- Mount brake disk (2) .
- Replace screws.
Parts: Screws
- Insert screws (1)
and tighten.TIGHTENING TORQUES SPECIFICATION
Brake disc to rear wheel hub M8
Replace screw.Tightening torque 16 Nm - Mount brake anchor plate.
- Replace screws (1) .
- Parts:
Screws
Insert screws (1) and tighten.
TIGHTENING TORQUES SPECIFICATION
| Brake anchor plate to rear wheel carrier | ||
|---|---|---|
| M12 Replace screw. |
Tightening torque | 130 Nm |
Follow-up work
- Refer to GREASING THE BRAKE PADS, THE BRAKE ANCHOR PLATE AND THE BRAKE CALIPER WITH BRAKE PAD PASTE .
- Refer to INSTALLING REAR BRAKE PADS .
- Refer to INSTALLING REAR BRAKE PAD WEAR SENSOR .
- Refer to INSTALLING REAR WHEEL ON THE LEFT AND RIGHT .
- Refer to START-UP OR BEDDING IN BREAK-IN OF NEW BRAKE PADS AND ROTORS (REAR BRAKE) .