Remove the prop shaft front at the front axle transmission
Preliminary work
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to REMOVING THE FRONT THRUST FIELD .
- Refer to REMOVING THE STIFFENING PLATE .
- Refer to REMOVING REAR UNDERBODY PROTECTION .
- Refer to REMOVING THE UNDERBODY PLANKING OF THE TRANSMISSION ON THE SIDE .
- Refer to REMOVING TRANSMISSION CROSS-MEMBER .
- Refer to REMOVING THE REAR DIFFUSER .
- Refer to REMOVING THE TRIM FROM THE REAR BUMPER PANEL .
- Refer to REMOVING BOTH EXHAUST TAILPIPE TRIMS .
- Refer to REMOVING THE CONNECTING SUPPORT FROM THE TUNNEL .
- Refer to REMOVING EXHAUST SYSTEM .
- Refer to REMOVING THE HEAT SHIELDS .
- Refer to REMOVING THE RETAINING PLATES .
- Refer to PARTIALLY LOOSENING THE PROP SHAFT .
- Refer to REMOVING THE TRANSFER BOX (ATC 13-1) .
- Refer to REMOVING EXHAUST BRACKET ON LEFT OF TRANSMISSION .
- Refer to DISCONNECTING HYDRAULIC LINES TO TRANSMISSION OIL COOLER .