Installing the alternator
- Slightly push back the threaded support sleeve (2) in the direction of arrow to facilitate the installation of the alternator.
- Screw the screw (1) into the threaded support sleeve (2) .
- Press back the threaded support bushing (2) using the bolt (1) .
- Unscrew the screw (1)
from the threaded support bushing (2)
.
- Insert and install the alternator (2) .
- Tighten the screws (1).TIGHTENING TORQUES SPECIFICATION
Alternator on component carrier M10x75 Tightening torque 38 Nm M10x125 Tightening torque 38 Nm M10x90 Tightening torque 38 Nm - Tighten nut (1)
.TIGHTENING TORQUES SPECIFICATION
Positive battery cable to the alternator M8 Tightening torque 19 Nm - Connect connectors (2)
and lock.
The connector (2) must engage audibly.
Follow-up work
- Refer to INSTALLING THE DRIVE BELT FOR ALTERNATOR .
- Refer to INSTALLING THE THROTTLE BODY .
- Refer to INSTALLING CHARGE AIR LINE .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING CLEAN AIR PIPE .
- Refer to INSTALLING INTAKE FILTER HOUSING .
- Refer to INSTALLING THE REAR CROSS CONNECTION .
- Refer to INSTALLING FRONT-END STRUT ON LEFT AND RIGHT .
- Refer to INSTALLING FRONT CROSS CONNECTION .
- Refer to INSTALLING THE SEAL FOR THE HOOD GASKET LEFT AND RIGHT .
- Refer to INSTALLING THE FRONT HOOD SEAL .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to ACTIVATING VEHICLE ELECTRICAL SYSTEM .
- Refer to WHEN REPLACING THE ALTERNATOR/ALTERNATOR REGULATOR: RESET GENERATOR STATISTICAL DATA .