Installing thrust field on the shock tower
- Position stiffening plate (3) .
- Replace screws (1)
and (2)
.
Parts : Screws
- Tighten the bolts (1)
with the special tool 0 490 504 (00 9 120)
.TIGHTENING TORQUE SPECIFICATION
Stiffening plate to shock tower M10 x42.5 Replace screws. Joining torque 56 Nm Angle of rotation 90° - Tighten the bolts (2)
with the special tool 0 490 504 (00 9 120)
.TIGHTENING TORQUE SPECIFICATION
Stiffening plate to cowl M10x17 Replace screws. Joining torque 56 Nm Angle of rotation 90°
Follow-up work
- Refer to INSTALLING THE COMPLETE REAR HOOD SEAL .
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .