Installing the rear mid-range speaker
- For equipment with HiFi speaker system:
- Fit the mid-range speaker (2) on the speaker holder (3) .
- Tighten down screws (1)
.TIGHTENING TORQUE SPECIFICATION
Loudspeaker to support/support to dashboard/support to body Screw Tightening torque 1.8 Nm - For equipment with HiFi speaker system:
- Position the speaker holder (2) .
- Connect all plug connections and clip in the cable bracket.
- Tighten down screws (1)
.TIGHTENING TORQUE SPECIFICATION
Loudspeaker to support/support to dashboard/support to body Screw Tightening torque 1.8 Nm
- For equipment with Harman Kardon speaker system:
- Loosen screws (1) .
- Remove the mid-range speaker (2)
from the speaker holder (3)
.
Follow-up work
- Refer to ATTACHING THE INNER PANEL FOR THE LUGGAGE COMPARTMENT PARTITION WALL .
- Refer to INSTALLING THE REAR CENTER CONSOLE TRIM .
- Refer to INSTALLING LEFT AND RIGHT REAR SIDE TRIM PANEL .
- Refer to INSTALLING THE TRIM PANEL FOR THE LEFT AND RIGHT BODY PILLAR .
- Refer to INSTALLING THE LEFT AND RIGHT SEATBELT FINISHER STRIP .
- Refer to INSTALLING THE TRIM PANEL FOR THE TOP ROLLOVER PROTECTION .
- Refer to INSTALLING THE STORAGE NET .