51 16 366 Removing and installing/replacing right glove box with housing

When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).

Necessary preliminary tasks:

IMPORTANT: Risk of damage!

Mask dashboard in area (1) above glove box.

Fig 1: Identifying Glove Box Mask Dashboard Area

Courtesy of BMW OF NORTH AMERICA, INC.

Open glove box cover.

Lever out protective caps and release screws underneath.

Fig 2: Locating Glove Box Cover Protective Caps

Courtesy of BMW OF NORTH AMERICA, INC.

Pull out glove box by approx. 10 cm.

Unlock plug connections (1) and disconnect.

Remove glove box in direction of arrow.

Fig 3: Removing Glove Box

Courtesy of BMW OF NORTH AMERICA, INC.

When replacing, remount the following parts according to the equipment: