51 16 383 Removing and installing/replacing damper for glove box

When working on trim panel components, make sure that visible surfaces are not scratched or damaged (e.g. by sharp-edged tools).

Necessary preliminary tasks: 

• Remove GLOVE BOX 

Unclip damper (1) from retaining bracket (2) and slide back in direction of arrow.

Fig 1: Unclipping Damper From Retaining Bracket

Courtesy of BMW OF NORTH AMERICA, INC.

Turn damper (1) approx. 90° in direction of arrow and disconnect.

Fig 2: Turning Damper

Courtesy of BMW OF NORTH AMERICA, INC.