51 45 030 Removing and installing instrument panel trim
Disconnect battery negative lead. See 12 00... INSTRUCTIONS FOR DISCONNECTING AND CONNECTING BATTERY
Remove fixture for steering column switch. See STEERING COLUMN
Remove center console. See 51 16 200 Removing and installing storage tray
Remove trim for center console. See 51 16 211 Removing and installing/replacing finisher for storage tray
Remove right glovebox. See 51 16 360 Removing and installing right glove box
Remove all clip-fitted trims (on instrument panel). See 51 16 221 Replacing a clipped-in trim (decorative strip on panel for instrument panel, front or rear door)
Remove carrier in center console. See 51 16... Removing and installing/replacing carrier in storage tray
Remove both panels for front roof pillar. See 51 43 201 Removing and installing or replacing trim for front left or right roof
Remove light switch unit. See 61 31 033 REMOVING AND INSTALLING LIGHT SWITCH UNIT
Remove complete instrument carrier. See 62 21 000 REMOVING AND INSTALLING COMPLETE INSTRUMENT CARRIER
Remove heating controls. See 64 11 750 REMOVING AND INSTALLING HEATING CONTROL (HEATER)
If necessary, remove radio receiver. See 65 11 030 REMOVING AND INSTALLING/REPLACING RADIO RECEIVER (BUILT-IN UNIT)
Remove airbag module on passenger side. See REMOVAL & INSTALLATION
If necessary, release screw (1).
Remove glovebox light (1) from opening (2).
Disconnect plug connection and remove glovebox light (1).
Release screws (1).
If necessary, release pin (2).
Remove insert (3) towards bottom.
Feed out wire (1) for glovebox light from guides (2).
Disconnect plug (1) and feed out cable (2) from guides.
Press panel (1) somewhat to rear and remove from guides (2).
Feed out clip (3) on panel (1) to front/right.
Disconnect plug connection (1) and remove panel.
Installation:
Retaining pins (2) and clip (3) must not be damaged.
Release screws (1).
Remove defroster nozzle (2) towards rear.
Remove screw or expansion rivet lower section (1).
Instrument panel (2), right.
Slacken nut (1).
Disconnect plug connection (1) for solar sensor.
Unscrew nuts (1).
Move front seats as far back as possible.
Apply handbrake fully.
Pull out instrument panel (2) towards rear and lift out through front right door.
Installation:
Push guide (1) into locator (2).
Installation:
Screw down shelf (1) and instrument panel trim (2) with screws (3) and center.
Loosen nut (4).
Center shelf (1) and instrument panel trim (2) and tighten nut (4).