LEMON Manuals: Even more car manuals for everyone
Home >> BMW >> 2018 >> M4 2D Convertible, Automatic DCT Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Air Bag Restraint Systems) >> Removal & Installation >> Passenger-Side Air Bag Module (3-Spoke Steering Wheel) >> Removal & Installation

Removal & Installation

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2003 BMW M3, 2003 BMW 330xi, 2003 BMW 330i, 2003 BMW 330Ci, and 2003 BMW 325xi. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. Remove passenger-side instrument panel air vent. Insert Plastic Wedge (00 9 323) on both sides of passenger-side air bag cover and release catches. Remove screw and lift off air bag cover. DO NOT allow tension to occur on air bag cover strap(s) when removing passenger-side air bag or cover. Remove retaining nuts and lift passenger-side air bag module from instrument panel and disconnect electrical connector. Remove air bag module from vehicle.
  3. To install, reverse removal procedure. Tighten passenger-side air bag module retaining nuts to specification. See TORQUE SPECIFICATIONS . Activate air bag system. See ACTIVATING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
scientia non olet · About LEMON Manuals