Installing the right radial shaft seal on the differential (AISIN GA8G45)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Coat sealing lips of new outer radial shaft seal with clean transmission oil.
- Use special tools 2 408 150 and 2 413 037 to drive in the outer radial shaft seal up to the stop.
Follow-up work
- Refer to INSTALLING THE TRANSFER BOX (VTG) .
- Refer to INSTALLING THE HOLDER WITH THE RUBBER MOUNT .
- Refer to INSTALLING THE INTERMEDIATE SHAFT WITH THE SUPPORT TUBE .
- Refer to INSTALLING INTERMEDIATE SHAFT WITH SUPPORT TUBE .
- Refer to INSTALLING STARTER MOTOR .
- Refer to PARTIALLY INSTALLING RIGHT OUTPUT SHAFT .
- Refer to INSTALLING THE FRONT RIGHT WHEEL ARCH COVER .
- Refer to MOUNTING THE WHEEL .
- Refer to INSTALLING PROP SHAFT .
- Refer to INSTALLING THE REAR HEAT SHIELD .
- Refer to INSTALLING FRONT HEAT SHIELD .
- Refer to INSTALLING EXHAUST SYSTEM .
- Refer to INSTALLING THE CROSS-MEMBER WITH TORSION STRUTS .
- Refer to INSTALLING THE CONNECTING SUPPORT ON THE TUNNEL AT FRONT AND REAR .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .
- Refer to CONNECTING THE BATTERY EARTH LEAD .