Installing the holder with the rubber mount
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Insert and install the holder (3).
- Tighten the screws (1) and (2) hand-tight.
- Lower jack.
- Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATIONS
| Holder to front axle support | ||
|---|---|---|
| M12 | Tightening torque | 100 Nm |
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Holder to oil pan | ||
|---|---|---|
| M12 | Tightening torque | 100 Nm |
Follow-up work
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .