11 61 051 Replacing intake plenum: Notes

Vehicle may slip off the vehicle hoist if the vehicle hoist is handled incorrectly. 

• Observe safety instructions on raising the vehicle using a vehicle hoist.
• For additional information see: LIFTING THE VEHICLE USING A VEHICLE HOIST .

Materials harmful to health. 

Contact with fluids harmful to health! 

• Note and follow safety instructions on containers.
• Conduct all work in appropriate personal protective equipment only.

Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.

Notes on work at the cooling system form the basis of these repair instructions and must be complied with at all times.

For additional information see: INSTRUCTIONS FOR REPAIR WORK ON COOLING SYSTEM .

Preliminary work 

• Refer to DISCONNECTING ALL BATTERY GROUND LEADS
• Refer to REMOVING THE ACOUSTIC COVER
• Remove the cover in the left engine compartment
• Remove the right cover in the engine compartment
• Refer to REMOVING TRAILING LINK AT SPRING STRUT DOME
• Remove the sound insulation on the bulkhead upper part at the center
• Refer to REMOVING ACOUSTIC COVER AT REAR
• Refer to REMOVING THE FRONT UNDERBODY PROTECTION
• Refer to DRAINING THE COOLANT FROM THE LOW-TEMPERATURE COOLING SYSTEM
• Refer to UNINSTALLING COVER FOR THE DME CONTROL UNIT
• Refer to REMOVING THE INTEGRATED POWER SUPPLY MODULE (PDM)
• Refer to DISCONNECTING THE CONNECTOR FROM THE DME CONTROL UNIT AND FROM THE POWER DISTRIBUTION MODULE (PDM)
• Refer to REMOVING THE DME CONTROL UNIT
• Refer to REMOVING THE HOLDER FOR THE DIGITAL MOTOR ELECTRONICS-CONTROL UNIT
• Refer to REMOVING TANK VENT VALVE
• Refer to REMOVING THE THROTTLE BODY

Follow-up work 

• Refer to INSTALLING THE THROTTLE BODY 
• Refer to INSTALLING THE TANK VENT VALVE
• Refer to INSTALLING THE HOLDER FOR THE DIGITAL MOTOR ELECTRONICS-CONTROL UNIT
• Refer to INSTALLING THE DME CONTROL UNIT
• Refer to INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM)
• Refer to CONNECTING THE CONNECTOR TO THE DME CONTROL UNIT AND THE POWER DISTRIBUTION BOX (PDM)
• Install cover for the DME control unit
• Refer to CONNECTING THE COOLANT HOSE TO THE RADIATOR OF THE LOW-TEMPERATURE COOLANT CIRCUIT
• Refer to FILLING THE LOW-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLER DEVICE
• Refer to INSTALLING ACOUSTIC COVER AT REAR
• Install the sound insulation on the bulkhead upper part at the center
• Install tension strut on spring strut dome. Jointing torque: 56 Nm, angle of rotation: 90°
  NOTE: Replace screws.
• Refer to INSTALLING ACOUSTIC COVER
• Install the cover in the engine compartment on the right
• Install the cover in the engine compartment on the left
• Refer to CONNECTING ALL BATTERY GROUND LEADS
• Refer to BLEEDING THE LOW-TEMPERATURE COOLING SYSTEM
• Install the front underbody protection