Removing and installing trailing link on spring strut dome
WARNING: This page is about a different car, the 2018 BMW 340i, 2017 BMW 340i, and 2016 BMW 340i. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Driving without the trailing link is not permitted.
(risk of damage to the body).
(risk of damage to the body).
Lever out covers (1) and release screws underneath.
Release screws (2) and remove trailing link (3).
Installation note:
Replace screws and tighten to specified torque and then to angle of rotation.
Jointing torque: 56 Nm.
Angle of rotation: 90°.