Install the hydraulic valve for the oil pressure control
- Replace O-ring (1).
Parts: O-ring
- Oil O-ring (1).
- Install the hydraulic valve (1).
- Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATIONS
| Hydraulic valve to engine block | |
| M6x18 | 8 Nm |
- Connect connector (1).
Follow-up work
- Refer to INSTALLING COMPLETE FULL-FLOW OIL FILTER .
- Refer to INSTALLING THE HEAT EXCHANGER FOR THE AUTOMATIC TRANSMISSION .
- Refer to INSTALLING CONNECTING BRACKET ON THE ENGINE BLOCK .
- Refer to INSTALLING THE INTAKE PLENUM .
- Refer to INSTALLING CHARGE AIR LINE .
- Refer to INSTALLING CLEAN AIR PIPE .
- Refer to INSTALLING INTAKE SILENCER HOUSING .
- Refer to INSTALLING CORROSION PROTECTION COVER .
- Refer to INSTALLING SOUND INSULATION AT THE CENTER OF THE BULKHEAD UPPER PART .
- Refer to REMOVING/INSTALLING TRAILING LINK AT TENSION STRUT TOWER .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE DESIGN COVER .
- Refer to INSTALLING CONTROL UNIT HOLDER .
- Refer to INSTALLING BATTERY HOUSING (ENGINE COMPARTMENT) .
- Refer to INSTALLING AUXILIARY BATTERY (ENGINE COMPARTMENT) .
- Refer to CONNECTING NEGATIVE BATTERY CABLE (ENGINE COMPARTMENT) .
- Refer to CONNECTING THE NEGATIVE BATTERY CABLE .
- Refer to ACTIVATING HIGH-VOLTAGE SYSTEM .
- Refer to INSTALLING THE FLAP IN THE RIGHT LUGGAGE COMPARTMENT TRIM PANEL .
- Refer to CONNECTING THE COOLANT LINE TO THE LOW-TEMPERATURE COOLING SYSTEM .
- Refer to INSTALLING BOTH COOLANT EXPANSION TANKS .
- Refer to FILLING THE LOW-TEMPERATURE COOLANT CIRCUIT WITH THE VACUUM FILLER DEVICE .
- Refer to BLEEDING THE LOW-TEMPERATURE COOLING SYSTEM .
- Refer to CHECKING LOW-TEMPERATURE COOLING SYSTEM FOR WATERTIGHTNESS .
- Refer to INSTALLING THE UNDERBODY PANELLING ON THE SIDES .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .
- Refer to TOPPING UP THE MOTOR OIL .