Removing the wastegate valve controller for the exhaust turbocharger on the left
NOTE:
TECHNICAL INFORMATION
Perform wheel alignment after installation.
Perform wheel alignment after installation.
Preliminary work
- Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING THE COVER FOR THE CENTER ENGINE COMPARTMENT .
- Refer to REMOVING LEFT INTAKE SILENCER HOUSING .
- Refer to REMOVING THE COVER OF THE ENGINE COMPARTMENT AT THE REAR LEFT .
- Refer to REMOVING THE COVER OF THE REAR RIGHT ENGINE COMPARTMENT .
- Refer to REMOVING THE COWL COVER .
- Refer to REMOVING TRAILING LINK AT SPRING BOLT .
- Refer to REMOVING THE SEAL FOR THE HOOD REAR .
- Refer to REMOVING THE COWL UPPER PART IN THE CENTER .
- Refer to REMOVING TOP CLEAN AIR PIPE AT LEFT .
- Refer to REMOVING LEFT THROTTLE VALVE ASSEMBLY .
- Refer to REMOVING CHARGE AIR PIPE ON LEFT .
- Refer to REMOVING THE FRONT LEFT AND RIGHT WHEELS .
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION OR FRONT THRUST FIELD .
- Refer to REMOVING THE COVER FOR THE STEERING ASSEMBLY ON THE RIGHT .
- Refer to REMOVING THE FRONT THRUST FIELD .
- Refer to REMOVING THE STIFFENING PLATE .
- Refer to REMOVING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER .
- Refer to RELEASING THE WIRING HARNESS FROM THE ACTIVE STABILIZER .
- Refer to REMOVING THE UNIVERSAL JOINT ON THE STEERING GEAR .
- Refer to REMOVING THE UNIVERSAL JOINT AT THE LOWER STEERING SHAFT .
- Refer to LOOSENING THE ANTI-ROLL BAR LINK ON THE LEFT AND RIGHT FROM THE ANTI-ROLL BAR .
- Refer to REMOVING BOTH TRACK END RODS .
- Refer to REMOVING THE STEERING GEAR .
- Refer to REMOVING THE COVER FOR THE CENTER ENGINE COMPARTMENT .
- Refer to REMOVING FRONT ORNAMENTAL GRILLE .
- Refer to PARTIALLY REMOVING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER .
- Refer to REMOVING FRONT BUMPER COVER .
- Refer to REMOVING BOTH HEADLIGHTS .
- Refer to REMOVING THE CENTER TOP CROSS CONNECTION .
- Refer to REMOVING THE FANFARE HORN ON THE LEFT .
- Refer to REMOVING THE FANFARE HORN TOWARDS THE RIGHT .
- Refer to REMOVING RIGHT INTAKE SILENCER HOUSING .
- Refer to REMOVING THE LEFT-HAND AIR DUCT .
- Refer to REMOVING RIGHT AIR DUCT .
- Refer to REMOVING LEFT INTAKE PORT .
- Refer to REMOVING THE REAR TOP CROSS CONNECTION .
- Refer to REMOVING FAN COWL .
- Refer to INSTALLING THE PROTECTIVE SHIELD ON THE RADIATOR .
- Refer to REMOVING THE DRIVE BELT FOR ALTERNATOR 2 AND THE AIR CONDITIONING COMPRESSOR .
- Refer to PARTIALLY DETACHING THE AIR CONDITIONING COMPRESSOR .
- Refer to REMOVING THE HEATER RETURNING HOSE FROM THE COOLANT PUMP .
- Refer to DETACHING ALTERNATOR 2 AND SET IT ASIDE .
- Refer to REMOVING LEFT CLEAN AIR PIPE .
- Unlock plug connection (1)
and disconnect.
- Detach the circlip (1) with a suitable tool.
- Detach the connecting rod.
- Loosen screws (1) .
- Remove the wastegate valve controller for the exhaust turbocharger.