Install door lock

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.

Attach the Bowden cable nipple (2).
Attach the Bowden cable (1).

Courtesy of BMW OF NORTH AMERICA, INC.
Attach the linkage (1) in the door lock (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Guide in the door lock (1) together with the outside door handle support (2) in the door.
Make sure the new seal from the door lock is not damaged during installation.

Courtesy of BMW OF NORTH AMERICA, INC.
Feed the support (2) into the mounting towards the rear.

Tighten down screw (1).

TIGHTENING TORQUE SPECIFICATIONS

Outside door handle support to door
screw	Tightening torque	2.6 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Screw in screws (2), and (3) a few turns.

First tighten the screws (2).

TIGHTENING TORQUE SPECIFICATIONS

Door lock to door
screw	Tightening torque	8.8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Then tighten screw (3).

TIGHTENING TORQUE SPECIFICATIONS

Door lock to door
screw	Tightening torque	8.8 Nm

Clip in locking rod (1).
Connect and lock the connector (1) on the door lock.
Fasten the vehicle wiring harness (2) on the door lock and on the outside door handle support.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to PARTIALLY INSTALLING THE POWER WINDOWS .
Refer to INSTALLING THE OUTSIDE DOOR HANDLE .
Refer to INSTALLING THE COVER ON THE OUTSIDE DOOR HANDLE .
Refer to INSTALLING SOUND INSULATION ON FRONT DOOR .
Refer to INSTALLING FRONT DOOR TRIM PANEL .
Refer to INSTALLING THE COVER ON THE DOOR HANDLE .