Install the high-pressure line between the high-pressure rail and the high-pressure pump
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2023 BMW X2, 2022 BMW X2, 2021 BMW X2, 2020 BMW X2, and 2019 BMW X2. However, it is still accessible from the selected car via links, so may be relevant.
- Feed in high pressure line (1) and position.
- Hand-tighten the union nut (2) on the rail (3).
- Hand-tighten the union nut (4) on the high pressure pump (5).
- Tighten union nut (2) on rail (3).
TIGHTENING TORQUE SPECIFICATIONS
| High pressure fuel line between the rail and the high pressure pump | ||
|---|---|---|
| M14 | tightening torque | 33 Nm |
- Tighten the union nut (4) on the high pressure pump (5).
TIGHTENING TORQUE SPECIFICATIONS
| High pressure fuel line between the rail and the high pressure pump | ||
|---|---|---|
| M14 | tightening torque | 33 Nm |
- Insert and install the sound insulation (2).
- Connect and lock the connector (1).
- Make sure the connector (1) engages audibly.
NOTE:
The following step(s) must be performed if the listed component(s) is/are installed.
- Guide in and install the cover (1).
Follow-up work
- Refer to INSTALLING THE IGNITION COILS .
- Refer to IF INSTALLED: PARTIALLY INSTALLING ENGINE VENTILATION LINE .
- Refer to INSTALLING THE UPPER FIREWALL COVER PANEL .
- Refer to INSTALLING THE STRUT BRACE .
- Refer to INSTALLING FRONT WINDSHIELD PANEL COVER .
- Refer to INSTALLING THE REAR HOOD SEAL .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to CONNECTING THE BATTERY EARTH LEAD .