67 62 000 Removing and installing or replacing flat motor for front left or right power window regulator

NOTE: RISK OF DAMAGE
Scratches.
Tools and sharp-edged components can cause scratches.

Protect working area.
Handle tools and components carefully.

NOTE: TECHNICAL INFORMATION
Notes on power window initialization must be strictly observed for these repair instructions.
Additional information, see NOTES ON INITIALIZING POWER WINDOWS ... Information on power window initialization.

NOTE: Description is for left component only. Procedure on the right side is identical.

Preliminary work

Remove the FRONT LEFT OR RIGHT DOOR HANDLE COVER
Remove the SWITCH TRIM ON LEFT OR RIGHT FRONT DOOR TRIM PANEL
Remove the FRONT DOOR TRIM PANEL ON LEFT OR RIGHT
Remove the SOUND INSULATION FROM THE FRONT DOOR
Remove the FRONT POWER WINDOW REGULATOR

Remove the flat motor for the front power window regulator

Unscrew the bolts (arrows) and remove the flat motor (1) from the power window regulator (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Install the flat motor for the front power window regulator

Insert the flat motor (1) into the power window (2).
Tighten screws (arrows).

TIGHTENING TORQUES SPECIFICATION

Flat motor on power windows
	6 N.m

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Install the POWER WINDOWS
Install the I SOUND INSULATION ON FRONT DOOR
Install the FRONT DOOR TRIM PANEL ON LEFT OR RIGHT
Refer to SWITCH TRIM ON THE FRONT LEFT OR RIGHT FRONT DOOR TRIM PANEL
Fix the FRONT LEFT OR RIGHT DOOR HANDLE COVER
Perform functional check of the power window, and if necessary, refer to NOTES on initializing power windows.