Install front engine encapsulation

Preliminary work 

• Refer to REMOVING THE ACOUSTIC COVER .
• Refer to REMOVING DESIGN COVER .
• Refer to REMOVING THE FRONT UNDERBODY PROTECTION .
• Refer to REMOVING BOTH COOLANT EXPANSION TANKS .
• Refer to REMOVING CLEAN AIR PIPE .
• Refer to REMOVING CHARGE AIR LINE .
• Refer to REMOVING ACOUSTIC COVER AT FRONT .
• Refer to REMOVING THE AUXILIARY COOLANT PUMP OF THE EXHAUST TURBOCHARGER .

• Check the engine encapsulation (1)  for damage and replace if necessary.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Carefully pull the engine wiring harness (1)  forward.
• Insert the engine encapsulation (2)  from the top.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Connect the connector (3)  with the heat management module.
• Connect the connector (2)  to the heating element.
• Connect the connector (1)  to the exhaust turbocharger.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Secure the engine encapsulation with the expanding rivet (2). 
• Connect connector (1). 

  Courtesy of BMW OF NORTH AMERICA, INC.

• Clip in the engine wiring harness (1)  in the highlighted areas.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Replace the O-ring for the oil feed line.

  Parts:  O-ring

• Position oil feed line (2). 
• Tighten down screw (1). 

Courtesy of BMW OF NORTH AMERICA, INC.