Install catalytic converter
Prepare the catalytic converter
- Feed in and install catalytic converter (3).
- Feed in and install V-band clamp (2).
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Catalytic converter to turbocharger | |
| M8 Replace V-band clamp. |
Tightening torque 32 Nm |
- Insert and install the holder (4).
- Tighten down screws (3).
TIGHTENING TORQUE SPECIFICATIONS
| Holder, catalytic converter to transmission | |
| M12X100 | Tightening torque 66 Nm |
- Tighten nut (1).
TIGHTENING TORQUE SPECIFICATIONS
| Catalytic converter to holder, transmission | |
| M8 Replace nut. |
Tightening torque 19 Nm |
- Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATIONS
| Catalytic converter to holder, transmission | |
| M8 Replace screw. |
Tightening torque 19 Nm |
- Feed in and install connecting rod (1).
- Tighten screws (arrows).
TIGHTENING TORQUE SPECIFICATIONS
| Connecting rod on front axle support | |
| Screw | Tightening torque 3 Nm |
Follow-up work
- Refer to INSTALLING THE COMPLETE EXHAUST SYSTEM .
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
- Refer to INSTALLING THE FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE OXYGEN SENSOR MONITOR .
- Refer to INSTALLING LAMBDA OXYGEN SENSOR .
- Refer to INSTALLING CORROSION PROTECTION COVER .
- Refer to INSTALLING SOUND INSULATION AT THE CENTER OF THE BULKHEAD UPPER PART .
- Refer to InstallIing tension strut on SPRING STRUT TOWER .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE LEFT .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE RIGHT .
- Refer to INSTALLING INTAKE SILENCER HOUSING .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE DESIGN COVER .