Section 313 (Engine - Repair (N54))
WARNING: This page is about a different car, the 2013 BMW Z4, 2012 BMW Z4, 2011 BMW Z4, 2010 BMW Z4, and 2009 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
- Engine, General
- 11 00 039 Checking compression in all cylinders (N43/N53/N54)
- 00 Danger of poisoning if oil is ingested/absorbed through the skin
- Engine identification
- 11 00... Engine oil service (N54, N54T)
- 11 00 590 Exchange engine (N54, N54T)
- 11 00 Mounting engine on assembly stand (N54, N54T)
- 11 00... Overview of consumables (Electronic Parts Catalogue)
- 11..... Removing and installing/replacing acoustic cover (N54, N54T)
- 11 00 050 Removing and installing engine (N54, N54T)
- 00 Risk of injury if oil comes into contact with eyes and skin
- 00 Safety information for working on vehicles with automatic engine start-stop function (MSA)
- 00 Safety instructions for handling oil
- 11 00 670 Securing engine in installation position (N54, N54T)
- Cylinder Head And Cylinder Head Cover
- 11 12 729 Checking cylinder head for watertightness (N54, N54T)
- 11 12 719 Milling cylinder head sealing surface (N54, N54T)
- 11 12 100 Removing and installing cylinder head (N54, N54T)
- 11 12 000 Removing and installing/sealing cylinder head cover (N54, N54T)
- 11 12 101 Replacing cylinder head gasket (N54, N54T)
- Oil Sump
- Housing Cover
- Crankshaft With Bearing
- Flywheel
- Vibration Damper
- Connecting Rod With Bearing
- Piston With Rings And Pin
- V-Ribbed Belt With TENSIONER And Deflection Element
- Camshaft
- 11 31 505 Adjusting camshaft timing (N54, N54T)
- 11 31 005 Checking camshaft timing (N54, N54T)
- 11 31 090 Installing and removing/replacing chain tensioner piston (N54, N54T)
- 11 31 028 Removing and installing/replacing exhaust camshaft (N54/N54T)
- 11 31 025 Removing and installing/replacing intake camshaft (N54/N54T)
- 11 31 051 Replacing timing chain (N54, N54T)
- Rocker Arm With Bearing Mount
- Valves With Springs
- Variable Camshaft Timing
- Oil Supply
- Oil Pump With Filter And Drive
- Oil Filter And Lines
- 11 42 198 Removing and installing oil feed line for exhaust turbocharger (N54)
- 11 42 250 Removing and installing oil return line for exhaust turbocharger (N54)
- 11 42 248 Removing and installing/renewing the oil return line for exhaust turbocharger cyl. 1-3 (N54)
- 11 42 020 Removing and installing/replacing full-flow oil filter (N54, N54T)
- 11 42 035 Removing and installing/replacing thermostat housing (N54, N54T)
- Oil Cooler
- Water Pump With Drive
- Thermostat And Connections
- Intake Manifold
- Supercharger With Control
- Vacuum Pump
- Emission Control, Oxygen Sensor