17 11 100 Removing and installing/renewing coolant expansion tank (N63)

WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work

Drain COOLANT .
Remove left TRAILING LINK .
Remove left INTAKE PORT .
Release expansion tank for hydraulic steering or dynamic drive and place to one side. See REMOVING/INSTALLING/REPLACING FLUID RESERVOIR . For vehicles with Dynamic Drive, see REMOVING/INSTALLING/REPLACING OIL RESERVOIR (VEHICLES WITH DYNAMIC DRIVE) .

Release screw (1).

Tightening torque 17 10 2AZ .

Release and disconnect coolant hoses (2).

Raise expansion tank (3)

Fig 1: Identifying Coolant Hoses, Expansion Tank And Screw

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock connector (1) on coolant level switch and disconnect.

Remove expansion tank (2).

Fig 2: Identifying Coolant Expansion Tank And Connector

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble engine.

Top up COOLANT .

Check cooling system for LEAK TIGHTNESS .