32 41 033 Removing and installing power steering pump for power steering gear with active front steering (N63)
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2014 BMW X6, 2013 BMW X6, 2012 BMW X6, 2011 BMW X6, and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
DANGER OF POISONING
if oil is ingested/absorbed through the skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Seal off hydraulic lines with plugs.
Seal off hydraulic lines with plugs.
Necessary preliminary tasks:
- Draw off and dispose of hydraulic fluid from fluid reservoir
- Remove BELT PULLEY
- Remove FAN COWL
- Remove FRONT ASSEMBLY UNDERSIDE PROTECTION
Release union nut (2) and detach pressure line from power steering pump.
Release hose clamp (1) and detach suction line from power steering pump.
Disconnect plug connection on rear side of power steering pump.
Installation:
Make sure hydraulic lines are laid without tension and with sufficient spacing to adjoining components.
Align suction line by way of marking to connection on power steering pump.
Tightening torque 32 41 4AZ .
Release screws (1, 2) and remove power steering pump.
Installation:
Make sure screws are installed in correct positions.
- Screw (1) M10 x 50
- Screw (2) M10 x 130
Tightening torque 32 41 3AZ .
After installation:
- Fill and bleed HYDRAULIC SYSTEM
- Check pipe connections for leaks