67 31 530 Removing and installing/replacing drive unit for backrest angle adjustment

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary tasks:

Remove FRONT SEAT .
Remove rear panel on front seat backrest. See REAR PANEL (NORMAL / ELECTRIC SEAT) or REAR PANEL (COMFORT SEAT) .
Remove covers on front seat. See OUTER COVER and INNER COVER .

Unhook backrest cover (1) on left and right on backrest frame (2).

Fig 1: Unhooking Backrest Cover

Courtesy of BMW OF NORTH AMERICA, INC.

Remove metal retaining ring (1) on left and right in direction of arrow from drive rod (2).

Installation:

Always replace metal retaining ring (1).

Make sure metal retaining ring (1) is correctly seated.

Unscrew bolt (3).

Disconnect plug connection (4).

Fig 2: Removing Metal Retaining Ring

Courtesy of BMW OF NORTH AMERICA, INC.

Pull out drive rod (1) until drive unit for backrest angle adjustment (2) is free.

Installation:

Make sure drive rod (1) is correctly seated in drive unit for backrest angle adjustment (2).

Feed drive unit for backrest angle adjustment (2) out of backrest frame (3) and remove.

Fig 3: Pulling Out Drive Rod

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

INITIALIZE drive unit for backrest angle adjustment.