52 14 198 Removing and installing / replacing rear panel on left or right front seat backrest (normal / electric)

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

Operation is shown on the left seat. When removing from the right seat, transpose the pull and striking sides accordingly.

Grip between rear panel and backrest cover on door side until clip can be felt (do not pull).
At same time, firmly punch towards middle of seat on inner side (tunnel side) at top.
Upper retainers spring out of seat guide.
Pull rear panel up out of lower guides.

Fig 1: Pulling Rear Panel
Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Rear panel and clips must not be damaged.

Upper clips
Lower clips

Fig 2: Identifying Upper Clips And Lower Clips
Courtesy of BMW OF NORTH AMERICA, INC.