52 14 040 Removing and installing/replacing outer cover on left or right front seat (basic/electric)

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

If necessary, move seat fully forwards and upwards.

Remove trim:

Unclip at rear towards top side
Pull on belt opening to one side
Bend trim open slightly at top and bottom on actuating unit
Bend open slightly at top and bottom and pull outwards a little

Fig 1: Removing Trim
Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Retaining clips must not be damaged.

Fig 2: Identifying Retaining Clips

Courtesy of BMW OF NORTH AMERICA, INC.