67 31... Notes on initializing electric seat actuator drives

WARNING: This page is about a different car, the 2010 BMW 550i, 2009 BMW 550i, and 2008 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Initialization is carried out at the adjusting switch of the relevant seat.

In this process, the end positions of the relevant electric seat actuator drive are recorded and stored.

An initialization must be performed:

After replacing a drive unit for seat adjustment.
After replacing/programming control unit for seat adjustment.

Operating sequence for initialization:

Move corresponding seat actuator drive(s) into both end positions.