24 50 010 Replacing Emergency Actuator

WARNING: This page is about a different car, the 2008 BMW 760Li, 2007 BMW 760Li, 2006 BMW 760i, 2006 BMW 760Li, and 2005 BMW 760i. However, it is still accessible from the selected car via links, so may be relevant.

Remove automatic transmission. See 24 00 023 REMOVING AND INSTALLING AUTOMATIC TRANSMISSION (6HP26Z/6HP32Z)

Remove trim panel for pedal assembly. See 51 45 185 REMOVING AND INSTALLING/REPLACING TRIM FOR PEDAL ASSEMBLY

Release screws.

Place light module (1) to one side.

Fig 1: Identifying Light Module

Courtesy of BMW OF NORTH AMERICA, INC.

Remove accelerator pedal module. See 35 40 001 REMOVING AND INSTALLING/REPLACING ACCELERATOR PEDAL MODULE

Remove pedal bracket. See 35 11 000 REMOVING AND INSTALLING MOUNTING BLOCK FOR PEDALS

Remove left front seat. See 52 14 000 REMOVING AND INSTALLING LEFT OR RIGHT FRONT SEAT (NORMAL/ELECTRIC)

Remove front left entrance strip.

Remove panel from A-pillar at bottom left.

Remove panel from center console at bottom left.

Remove speaker frame in footwell carpet at front left.

Pull back footwell carpet on left under instrument panel.

Release screws (1) of emergency actuator (2).

Fig 2: Identifying Screws Of Emergency Actuator

Courtesy of BMW OF NORTH AMERICA, INC.

Unclip cable (1) and pull out.

Installation:

Insert sealing ring (2) in transmission tunnel.

Fig 3: Inserting Sealing Ring In Transmission Tunnel

Courtesy of BMW OF NORTH AMERICA, INC.