Bevel Box, Installing

WARNING: This page is about a different car, the 2024 Audi Q3 and 2023 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.

Procedure

Install in the reverse order of removal while noting the following:

-- Tighten the bevel box on the transmission.

-- Check the gear oil level. Refer to GEAR OIL, CHECKING LEVEL .

Tightening Specifications

Refer to BEVEL BOX, TIGHTENING SPECIFICATION
Refer to OVERVIEW - ASSEMBLY MOUNTS
Refer to OVERVIEW - DRIVE AXLE .
Refer to DRIVE AXLE HEAT SHIELD, REMOVING AND INSTALLING .
Refer to OVERVIEW - LOWER CONTROL ARM AND BALL JOINT .
Refer to OVERVIEW - DRIVESHAFT .
Refer to OVERVIEW - NOISE INSULATION .