Overview - Assembly Mounts

WARNING: This page is about a different car, the 2024 Audi Q3 and 2023 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Assembly Mounts

Courtesy of AUDI

Bolt
- Always replace after removing
- Tightening Specifications and Sequence. Refer to Fig 2.
Engine Support
- Removing and Installing. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .
Engine Mount
- With support arm
- Removing and Installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
Bolt
- Always replace after removing
- 40 Nm +90°
Bolt
- Always replace after removing
- 20 Nm +90°
Bolt
- Always replace after removing
- 40 Nm +90°
Bolt
- Always replace after removing
- 60 Nm +90°
Pendulum Support
- Removing and Installing. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING .
Bolt
- Always replace after removing
- Tightening Specifications and Sequence. Refer to Fig 3.
Bolt
- Always replace after removing
- Tightening Specifications and Sequence. Refer to Fig 3.
Bolt
- Always replace after removing
- Tightening Specifications and Sequence. Refer to Fig 3.
Bolt
- Always replace after removing
- 60 Nm +90°
Bolt
- Always replace after removing
- 60 Nm +90°
Transmission Mount
- With support arm
- Removing and Installing. Refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING .
Bolt
- Always replace after removing
- 50 Nm + 90°

Engine Support - Tightening Specification and Sequence

Fig 2: Engine Support - Tightening Sequence

Courtesy of AUDI

Replace the bolts that were tightened with an additional turn.

-- Tighten the bolts in the steps in the sequence shown:

Step	Bolts	Tightening specification/additional turn
1.	-1 to 3-	7 Nm
2.	-1 to 3-	40 Nm
3.	-1 to 3-	90° additional turn

Pendulum Support - Tightening Specifications and Sequence

Fig 3: Engine Support Component Location

Courtesy of AUDI

Replace the bolts that were tightened with an additional turn.

-- Tighten the bolts in the steps in the sequence shown:

Step	Bolts	Tightening specification/additional turn
1.	-2 and 3-	50 Nm
2.	-1-	130 Nm
3.	-1 to 3-	90° additional turn