Bevel Box, Tightening Specification

WARNING: This page is about a different car, the 2024 Audi Q3 and 2023 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.

Bevel Box on Dual-Clutch Transmission - Tightening Specification

Fig 1: Bevel Box Mounting Bolt Location

Courtesy of AUDI

Replace the bolts after removing them.

-- Tighten the bolts in steps as follows:

Step	Bolts	Tightening Specification/Additional Turn
1.	-arrows-	Install all the way by hand
2.	-arrows-	40 Nm diagonally
3.	-arrows-	90° additional turn, diagonally

Bevel Box to Transmission - Tightening Specification

Fig 2: Transmission Support To Engine And Bevel Box (Vehicles with 2.0L - 162-175 kW Engine)

Courtesy of AUDI

-- Tighten the bolts in steps as follows:

Step	Bolts	Tightening Specifications
1.	-1 and 2-	Install all the way by hand
2.	-2-	40 Nm
3.	-1-	40 Nm