Gear Oil, Checking Level
WARNING: This page is about a different car, the 2024 Audi Q3 and 2023 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Used Oil Collection and Extraction Unit:SMN372500
Requirements
- Wear protective eyewear.
- Bevel box must be in the installation position.
-- Lift the vehicle with all four lifting points of the hoist at the same height.
-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .
-- Place the :SMN372500 underneath.
-- Remove the oil filler hole plug -1-.
Replace the oil filler plug after removing.
Oil level is correct if bevel box is filled with oil as far as bottom edge of the oil fill hole.
-- Carefully remove leaking oil from the bevel box.
-- Add gear oil if necessary. Refer to GEAR OIL, DRAINING AND FILLING .
-- Install the new oil filler plug -1-.
-- Tighten the bolt to the tightening specification. Refer to Figure.