Passenger Seat Occupant Detection Sensor -G128-, REMOVING AND INSTALLING: Removing
-- Pay attention to the additional safety precautions for working on passenger occupant detection system for front passenger airbag deactivation, market-specific version. Refer to ADDITIONAL SAFETY PRECAUTIONS FOR WORKING ON PASSENGER OCCUPANT DETECTION SYSTEM FOR FRONT PASSENGER AIRBAG DEACTIVATION, MARKET-SPECIFIC VERSION .
-- Pay attention to the passenger occupant detection system deactivation after a collision, market-specific. Refer to PASSENGER OCCUPANT DETECTION SYSTEM DEACTIVATION AFTER A COLLISION, MARKET-SPECIFIC .
-- Remove the front passenger seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Attach the front seat to the seat repair bracket. Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .
-- Remove the backrest. Refer to FRONT BACKREST, REMOVING AND INSTALLING .
-- Remove the seat functions control module. Refer to COMPONENT LOCATION OVERVIEW - ELECTRIC AND ELECTRONIC COMPONENTS .
-- If installed, remove the pneumatic system compressor. Refer to OVERVIEW - PNEUMATIC SYSTEM .
-- Release and disconnect the connector for the Passenger Occupant Detection System Control Module -J706-.
-- Free up the electrical wire.
-- Remove the bracket for the seat frame trim panel/control module/compressor. Refer to OVERVIEW - SEAT PAN .
-- Disconnect the modular wiring routing. Refer to OVERVIEW - FRONT SEAT .
-- Open the corrugated tube and free up the wire.
-- Remove the nut -arrow A- and free up the wire.
-- Release and disconnect the connectors -B arrows- and free up the wire.
-- Unclip and free up the wiring harness from the seat pan.
-- Remove the cover and cushion on the seat pan. Refer to SEAT PAN COVER AND CUSHION, REMOVING AND INSTALLING .
-- If necessary, separate the cover and cushion from the seat pan. Refer to SEAT PAN COVER AND CUSHION, SEPARATING .