Overview - Engine Compartment Lid
WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Rear Lid
- Removing and Installing. Refer to REAR LID, REMOVING AND INSTALLING .
- Adjusting. Refer to REAR LID, ADJUSTING .
- Adjusting Buffer
- Removing and Installing. Refer to ADJUSTING BUFFER, REMOVING AND INSTALLING .
- Adjusting. Refer to HEIGHT, ADJUSTING USING ADJUSTING BUFFER .
- Stop
- For the adjusting buffer
- Ball Pin
- Quantity: 2
- 21 Nm
- Gas-Filled Strut
- Removing and Installing. Refer to GAS-FILLED STRUT, REMOVING AND INSTALLING .
- Venting. Refer to GAS-FILLED STRUT, VENTING .
- Bolt
- Quantity: 2
- 30 Nm
- Hinge Cover
- Bolt
- 21 Nm
- Hinge
- Removing and Installing. Refer to HINGES, REMOVING AND INSTALLING .
- Nut
- 21 Nm
- Body
- Roof Frame Cover
- Removing and Installing. Refer to ROOF FRAME COVER, REMOVING AND INSTALLING .
- Rear Lid Seal
- Removing and Installing. Refer to REAR LID SEAL, REMOVING AND INSTALLING .
- Release Button In Rear Lid Handle -E234-
- Component Location Overview. Refer to COMPONENT LOCATION OVERVIEW - CONTROLS IN LUGGAGE COMPARTMENT
- Latch
- Overview. Refer to Overview - Rear Lid Release .