Height, Adjusting Using Adjusting Buffer

WARNING: This page is about a different car, the 2024 Audi SQ7, 2024 Audi Q7, 2023 Audi SQ7, and 2023 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Adjustment dimensions. Refer to ADJUSTMENT DIMENSIONS .

Procedure

-- Install the adjusting screw -2- with the protective cap -1- all the way into the adjusting buffer -3- before adjusting the rear lid.

Fig 1: Adjusting Screw, Adjusting Buffer And Cap

Courtesy of AUDI

-- Remove the adjusting screw -2- just enough until the cap -1- makes contact with the stop on the body side with light pretension when the rear lid is closed.

-- Check if the lid is without play and in a flush position by pressing or pulling at the side edges of the rear lid.

-- Repeat the adjustment if necessary.