Hydraulic Pulse Memory, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Replace the O-ring and the bolts from the hydraulic pulse memory.

-- Install the hydraulic pulse memory -A- with a new O-ring -D-.

-- Tighten the bolt in the following sequence: -1 to 3-.

-- Disconnect the connector -B- for the hydraulic pulse memory -A- carefully.

NOTE:

Make sure the connector locks and is secure.

-- Route the wire -C- according to the illustration and secure it -arrows-.

-- Install the Automatic Transmission Fluid (ATF) filter. Refer to Installing .

-- Install the Automatic Transmission Fluid (ATF) pan. Refer to Installing .

-- Fill the Automatic Transmission Fluid (ATF). Refer to AUTOMATIC TRANSMISSION FLUID (ATF), DRAINING AND FILLING .