Automatic Transmission Fluid (ATF) Strainer, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi A7 Quattro, 2014 Audi A7 Quattro, 2013 Audi A7, and 2012 Audi A7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying ATF Filter O-Ring On Filter

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

-- Mount the O-ring -2- on the Automatic Transmission Fluid (ATF) filter -1-.

-- Clean both magnets -arrows-. Make sure the magnets completely contact the depressions in the Automatic Transmission Fluid (ATF) filter.

Fig 2: Locating And Cleaning Both Magnets

Courtesy of AUDI OF AMERICA, LLC

-- Mount the Automatic Transmission Fluid (ATF) filter on the Mechatronic.

Fig 3: Identifying ATF Filter Correct Mounting

Courtesy of AUDI OF AMERICA, LLC

The collar -1- on the Automatic Transmission Fluid (ATF) filter must be installed all the way into the opening -2- in the Mechatronic.
The mount -4- on the back must fit into the bolt -3- on the Mechatronic.

-- Install the Automatic Transmission Fluid (ATF) pan. Refer to Installing

-- Fill the Automatic Transmission Fluid (ATF). Refer to AUTOMATIC TRANSMISSION FLUID (ATF), DRAINING AND FILLING .