Windshield Washer Fluid Reservoir, Lines And Nozzle Overview: Notes

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Observe notes on contact corrosion, refer to CONTACT CORROSION .

Fig 1: Identifying Windshield Washer Fluid Reservoir, Lines And Nozzle Overview

Courtesy of AUDI OF AMERICA, LLC

Windshield Washer Fluid Level Sensor -G33-
- Removing and installing, refer to WINDSHIELD WASHER FLUID LEVEL SENSOR -G33- .
Sealing Gommet
- Replace if damaged.
Screw
- Tightening sequence, refer to Washer Fluid Reservoir, Tightening Specifications and Sequence .
Screw
- Tightening sequence, refer to Washer Fluid Reservoir, Tightening Specifications and Sequence .
Screw
- 8 Nm
Screw
- 8 Nm
Washer Fluid Filler Tube
- For washer fluid reservoir.
- Removing and installing, refer to WASHER FLUID RESERVOIR FILLER NECK .
Cover
- For the filler neck.
Water Hose
- For windshield washer system.
Right Washer Nozzle
- Vehicles with Right washer nozzle heater -Z21-
- Removing and installing, refer to WINDSHIELD SPRAY NOZZLES .
- Adjusting. Refer to Maintenance Manual.
Left Washer Nozzle
- Vehicles with Left washer nozzle heater -Z20-
- Removing and installing, refer to WINDSHIELD SPRAY NOZZLES .
- Adjusting. Refer to Maintenance Manual.
Grommet
- For the windshield washer fluid hose inside the hood.
Grommet
- For the windshield washer fluid hose on the fender.
Sealing Grommet
- Replace if damaged.
O-ring
- Replace if damaged.
Washer Fluid Reservoir
- Removing and installing, refer to WASHER FLUID RESERVOIR .
Securing Tab
- For the mount inside the fender end plate.
Windshield Washer Pump -V5-
- Removing and installing, refer to WINDSHIELD WASHER PUMP -V5- .
Sealing Grommet
- Replace if damaged.