Windshield Washer Fluid Level Sensor -G33-

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Drip Tray

Observe notes on contact corrosion CONTACT CORROSION .

Removal

Fig 1: Disconnect Electrical Connector

Courtesy of AUDI OF AMERICA, LLC

-- Remove the left front wheel housing liner. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .

-- Place a drip tray under the windshield washer fluid reservoir.

-- Disconnect the electrical connector -1-.

-- Remove the windshield washer fluid level sensor -item 2- from the washer fluid reservoir.

Installation

Install in reverse order of removal, observing the following:

-- Check the sealing grommet -3- for damage.

-- Install the front wheel housing liner. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .