Washer Fluid Reservoir Filler Neck

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2015 Audi S7, 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, and 2014 Audi RS 7. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Drip Tray

Observe notes on contact corrosion CONTACT CORROSION .

Removal

Fig 1: Identifying Bolts

Courtesy of AUDI OF AMERICA, LLC

-- Place a drip tray under the windshield washer fluid reservoir.

-- Remove the plenum chamber cover. Refer to PLENUM CHAMBER COVER, REMOVING AND INSTALLING .

-- Remove the screws -arrows- and remove the connection -1- with the filler tube from the windshield washer fluid reservoir to the right side through the opening in the body.

Installation

Fig 2: Identifying Connection

Courtesy of AUDI OF AMERICA, LLC

Tightening specification, refer to WINDSHIELD WASHER FLUID RESERVOIR, LINES AND NOZZLE OVERVIEW .

Install in reverse order of removal, observing the following:

-- Slide the grommet -2- all the way onto the filler tube connection -1-.

The tab -3- must fit into the opening -arrow- on the filler tube.

-- Insert the filler connection into the windshield washer fluid reservoir.

NOTE:

Make sure the O-ring is not crushed when sliding it into the washer fluid reservoir.