Transmission Guided Functions: Procedure:: Notes

WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Vehicle Diagnostic Tester is connected.

-- Perform "Guided Function" in Guided Functions, directory 02 - transmission electronics, functions on the Vehicle Diagnostic Tester.

Conditions:

Follow the instructions on the Vehicle Diagnostic Tester exactly so that "Guided Functions" can be performed successfully.

Perform "Guided Functions" with a Vehicle Diagnostic Tester after performing the following:

Replacing the selector mechanism function unit: 02 - Basic Setting (Control Housing) . Refer to 1. Replacing The Shift Mechanism Function Unit .
Working on the selector lever cable, adjusting the selector lever cable: 02 - Basic Setting (Control Housing) . Refer to 2. Assembly Work On The Selector Lever Cable When Adjusting The Cable .
Replacing the S tronic Transmission Mechatronic -J743- and the Transmission Control Module -J217- : 02 - Replace Control Module/Mechatronic (Control Housing) . Refer to 3. Replacing The S Tronic Transmission Mechatronic -J743- And Transmission Control Module -J217- .
Replacing the dual clutch, Transmission Control Module -J217-. repairing the transmission, replacing the components in the transmission: 02- Basic Setting (Control Housing) . Refer to 4. Replacing The Dual Clutch .