Transmission Shaft Seals Overview
WARNING: This page is about a different variant/trim than selected.
The shaft seals -A and B- can only be replaced after the transmission has been removed. Refer to Removal and Installation .
The shaft seals -C, D and E- can be replaced with the transmission already installed.
NOTE:
The bearing pre-load for the tapered roller bearing must be adjusted when replacing the final drive cover - 2-. Refer to FINAL DRIVE COVER .
- A - Shaft Seal
- For the input shaft
- Replacing, refer to Removal and Installation
- B - Shaft Seal
- For left flange shaft
- Replacing, refer to Removal and Installation
- C - Shaft Seal
- For right flange shaft
- Removing and installing, refer to RIGHT FLANGE SHAFT SEAL
- D - Shaft Seal
- For the rear flange shaft or transmission output shaft with splines, refer to:
- REAR FLANGE SHAFT SEAL, REPLACING
- TRANSMISSION OUTPUT SHAFT SEAL WITH SPLINES, REPLACING, VEHICLES WITHOUT VIBRATION DAMPER ON THE TRANSMISSION OUTPUT SHAFT
- TRANSMISSION OUTPUT SHAFT SEAL WITH SPLINES, REPLACING, VEHICLES WITH VIBRATION DAMPER ON THE TRANSMISSION OUTPUT SHAFT
- E - Shaft Seal
- For the selector shaft
- Removing and installing, refer to SELECTOR SHAFT SEAL
- 1 - Right Flange Shaft
- Removing and installing, refer to RIGHT FLANGE SHAFT SEAL .
- 2 - Final Drive Cover
- Removing and installing, refer to FINAL DRIVE COVER
- 3 - O-ring
- On the final drive cover
- Removing and installing, refer to FINAL DRIVE COVER
- 4 - Differential
- 5 - Transmission
- 6 - Transmission Output Shaft with Splines
- With vibration damper;
- Replace the shaft seal when replacing the transmission output shaft with splines -D-
- 7 - Transmission Output Shaft with Splines
- Without vibration damper;
- Replace the shaft seal when replacing the transmission output shaft with splines -D-
- 8 - Dust Ring
- Replace after removing
- 9 - Rear Flange Shaft
- Removing and installing, refer to REAR FLANGE SHAFT SEAL, REPLACING .
- 10 - Left Flange Shaft
- Removing and installing, refer to Removal and Installation
- 11 - Clutch Module
- Removing and installing, refer to Removal and Installation
- 12 - Bolt
- 24 Nm
- Steel bolts (M8; 38 mm long)
- Quantity: 10