Dual-mass flywheel, component overview
WARNING: This page is about a different car, the 2008 Audi RS 4 and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
1 - Dual mass flywheel
- Removing and installing → Dual-mass flywheel, removing and installing
2 - Needle bearing
- Pulling out and driving in → Needle bearing on dual mass flywheel, pulling out and driving in
3 - Special bolt
- Replace
- Loosening and tightening Torque specification
4 - Crankshaft
5 - Crankshaft seal, timing chain side
- Replacing → Crankshaft seal (timing chain side), replacing .