Selector Mechanism, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Tightening specifications, refer to OVERVIEW - SELECTOR MECHANISM .

NOTE:

Lubricate the ball socket on the selector lever cable with Polycarbamide Grease G 052 142 A2 before installing.

Do not bend or kink the selector lever cable.

-- Adjust the selector lever cable, refer to SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .

-- Install the heat shield, refer to OVERVIEW - HEAT SHIELD .

-- Install tunnel crossmember, refer to OVERVIEW - SUBFRAME MOUNT .

-- Check the selector mechanism, refer to SELECTOR MECHANISM, CHECKING .

-- Align the exhaust system free of tension, refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .

-- Install the driveshaft, refer to DRIVESHAFT, REMOVING AND INSTALLING .

-- Install the subframe crossbrace, refer to INSTALLING .

-- Install the noise insulation, refer to OVERVIEW - NOISE INSULATION .

-- Install the front ashtray, refer to FRONT ASHTRAY, REMOVING AND INSTALLING .