Overview - Selector Mechanism
WARNING: This page is about a different car, the 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
There is a risk of injury and accident from accidentally engaging a gear when the engine is running.
- Before work is done with the engine running, move the selector lever into "P" and press the parking brake button to engage the electromechanical parking brake.
Before disassembling the selector mechanism, perform check, refer to SELECTOR MECHANISM, CHECKING .
- Selector Lever Handle
- Overview, refer to OVERVIEW - SELECTOR LEVER HANDLE
- Trim Ring
- Overview, refer to OVERVIEW - SELECTOR LEVER HANDLE
- Selector Lever Boot
- Overview, refer to OVERVIEW - SELECTOR LEVER HANDLE
- Clamp
- Overview, refer to OVERVIEW - SELECTOR LEVER HANDLE
- Selector Lever Transmission Range Position Display Unit -Y26-
- Nut
- Tightening specification: 10 Nm
- For securing the shift mechanism to the body
- Quantity: 4
- Seal
- Selector Lever Sensor System Control Module -J587- with Tiptronic Switch -F189-
- Removing and installing, refer to Selector Lever Sensor System Control Module -J587- WITH Tiptronic Switch -F189-, REMOVING AND INSTALLING
- Selector Mechanism Function Unit
- Can only be replaced as a unit
- Removing and installing, refer to SELECTOR MECHANISM, REMOVING AND INSTALLING
- Shift Lock Solenoid -N110-
- Removing and installing, refer to Shift Lock Solenoid -N110-, REMOVING AND INSTALLING
- Transmission Park Selector Switch -F305-
- Consists of two micro-switches on the circuit board on the Shift Lock Solenoid - N110-.
- Can only be replaced together with the Shift Lock Solenoid -N110-, refer to Shift Lock Solenoid -N110-, REMOVING AND INSTALLING .
- Noise Insulation
- Not on all vehicles .
- Lock Washers
- For securing the noise insulation to the shift mechanism function unit
- Quantity: 4
- Replacing
- Circlip
- Secure the selector lever cable to the selector mechanism function unit
- O-Ring
- Replacing
- Selector Lever Cable
- Do not bend
- Overview, refer to OVERVIEW - SELECTOR LEVER CABLE
- Cap
- Via the Shift Lock Solenoid -N110-