SUBFRAME CROSSBRACE, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
- The square nuts must be inserted into the cast recesses before installing the subframe shields, where applicable, refer to -item 16- Square Nut (See Figure).
Tightening specifications, refer to OVERVIEW - SUBFRAME, CROSSBRACE, STABILIZER BAR, COUPLING ROD AND SUBFRAME SHIELD .