Overview - SUBFRAME Mount
WARNING: This page is about a different car, the 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Nut
- Tightening specification: 20 Nm
- Only remove if the transmission mount must be separated from the transmission support
- Bolt
- Tightening specification: 70 Nm
- Bolt
- Tightening specification: 40 Nm
- Transmission
- Nut
- Tightening specification: 20 Nm
- Transmission Support
- Removing and installing, refer to TRANSMISSION SUPPORT WITH TRANSMISSION MOUNT, REMOVING AND INSTALLING
- Transmission Mount
- Removing and installing, refer to TRANSMISSION MOUNT, REMOVING AND INSTALLING
- Lower Stop
- For the transmission mount
- Bolt
- 20 Nm + 90° turn
- Replacing
- Only remove if the transmission mount must be separated from the transmission support
- Tunnel Crossmember
- Removing and installing, refer to TUNNEL CROSSMEMBER, REMOVING AND INSTALLING