Fan Shroud, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
- Tightening specification, refer to OVERVIEW - FAN SHROUD AND RADIATOR FAN .
NOTE:
Secure all hose connections with hose clamps of the same type as those equipped by the factory .
-- Tighten the ATF lines, refer to OVERVIEW - ATF CIRCUIT for 0BW, OVERVIEW - ATF CIRCUIT for 0BK, or OVERVIEW - ATF CIRCUIT for 0B6 .
-- Install the air guide, refer to OVERVIEW - AIR FILTER HOUSING .
-- Install the impact member, refer to IMPACT MEMBER, REMOVING AND INSTALLING .
-- Connect the connection to the coupling, refer to Figure.
-- Fill the coolant, refer to COOLANT, DRAINING AND FILLING and CHECK THE COOLANT LEVEL .
-- Check the ATF level, refer to ATF LEVEL, CHECKING for 0BW, ATF LEVEL, CHECKING for 0BK, or ATF LEVEL, CHECKING for 0B6 .